While we wait for the plasma cut boiler plates and housing to arrive I went back to a job that’s needed doing for a while on the engine; the Lubricator.
Approaches to lubrication
There are several approaches to lubricating a steam engine, from a hand-held oil can (tends to be a bit erratic, and you chop the end of the spout off in moving parts) thru oil wicks, to pumped lubrication. I felt that a pumped system was the way to go.
There are 11 bearings that need lubrication in the engine (3 main bearings, 2 big ends, 2 little ends/crossheads, and 4 eccentrics). Actually, there is cylinder lubrication as well, but we are going to deal with that via a separate displacement lubricator which injects oil into the incoming steam (a sort of 19-century “posi-lub”! Continue reading